Techno Linear Motion Catalog131Work Holding ComponentsADJUSTABLE TOGGLE CLAMP, made of steel, is ideal for holdingodd shaped parts. The front screw can be positioned along the slot whilethe rear screw adjusts the pressure on the part. Both M6 screws and anM6 T-slot nut are included with the clamp.HEAVY-DUTY CAM LOCK CLAMP, made of black oxidized hardenedsteel. This clamp will provide up to 2500 N of clamping force with 100 Nof actuating force. A 180 degree rotation of the locking arm will providea clamp stroke of 4 mm. 15 mm high, 32 mm wide, 107 mm overall length.Provided with two-hole nut strip and screws to allow mounting to a T-slot.CLAMP BARS, made of plated steel, 10 mm high and 20 mm wide inlengths to 250 mm. To be used with either the cam lock clamps or thepneumatic clamps to make a work holder. Provided with screws and nutsto allow mounting to a T-slot.PNEUMATIC CLAMP, made of hardened steel with a blackoxide finish, provided with screws and nuts for mounting to theT-slots and a fitting for 6 mm OD, 4 mm ID plastic pressure tube.MANUAL VISESare made of steel with side slots for flexible mounting.The moveable jaws have side guides and the stationary jaws have bothhorizontal and vertical V slots for holding round objects. Both jaws havesupport surfaces for holding flat objects.HL5400M290051Catalog NumberHL5400M290002Catalog NumberLength(mm)Catalog NumberHL5400M290020075HL5400M290020125HL5400M290020175HL5400M29002122575125175225Catalog NumberMaximumStrokeClampingForce(N at 6 bar)Dimensionsat min. length(mm)HL5400M290010105020H x 65W x 75LCatalog NumberMaximumStrokeHL5400M290055HL5400M290056152H x 130W x 45L215H x 175W x 75L6595OverallDimensions(mm)